Because of my knowledge limited in LabView instrument control, how should I approach of collecting the correct address of GPIB and recognize it in my VI?īefore we dig into the LabVIEW code, I would recommend a Test Panel of max aperture and trying to communicate with. I am currently trying to initialized the EMS with the GPIB driver I have attached below. I have attached an image below the address specified by IO Keysight connection Expert. However, I have problems my instrument drivers to recognize the GPIB address specified for the device. I am trying to use a GPIB-USB adapter to control a unit of Source of LabView. Ĭonnection of an instrument with GPIB-USB connection. It seems that you already know how to transfer the settings above, but here's a KB on how to do this. If you are really worried about it however, give it a try without getting rid of your original computer. I can't find anything that says that there will be problems with the little change. If the controller is 8 bits, but work with my 32-bit system already, can I export the config VISA file, change on a 64-bit of Windows 7 with a USB to GPIB computer, and import this file into a newer version of the driver 488.2? (change of bits or a more recent version of 488.2 will be a problem?)Īs long as you save this export config file, you should be able to load it into the second computer MAX. I have a Zeiss PCDMIS CMM running 32-bit on Windows XP with PCI GPIB (488.2 2.7.3) Using NI USB-GPIB controller Zeiss C90 CMM control I thank in advance for any help, you can provide on this subject. I would have thought the NI GPIB-USB-HS and the NI GPIB-USB-HS + both work on the same application without anyĬode changes just and necessary update the driver. I also had the same problem with communications with the bridges of cap and had to re - write programs using NI-VISA that the That is when I decided to check the controller has worked on the original PC and discovered that it is not. I tried to implement the same program on another PC and could never get the program to communicate with the tester using the I uninstalled the driver and returned to the NI GPIB-USB-HS controller and re-installed the driver appropriate for her and the program works. I installed the new driver for the NI GPIB-USB-HS +. When I try to use the NI GPIB-USB-HS + controller it does not work. The original code uses the 32-bit Visual Basic Language Interface Version 1.7 of National Instruments with the DLL of NOR-488. The existing work PC running Windows XP and use the NI GPIB-USB-HS and works very well. I have a visual basic program 6 which measure IR using a meter of high resistance of agilent 4339 B.

Ni gpib usb